There are many reasons for poor board-to-board connector contact. Poor board-to-board connector contact will cause board-to-board disconnection and failure, usually because the connector end is rusted and external dirt enters the terminal or the connection socket. This results in a decrease in contact pressure. At this time, we should remove the board-to-board connector and reinstall it to change its connection status, so that normal contact can be restored.
In addition, the board-to-board connector failure may also be caused by the poor contact of the board-to-board conductors. When a board-to-board connector has a short-circuit failure, it is very rare that the conductor is broken during use and the conductor is disconnected in the middle. Yes, most of them are disconnected at the connector. Therefore, we usually need to carefully check the wires in the connection to see if there is any bad contact. At the same time, pay attention to avoid the board-to-board connector from being invaded by moisture and dust. Wait.
Post time: Dec-31-2020
